Raspberry Pi -  Motor Wheel Encoder

Photoelectric Encoder  2 Port - Speed Sensor

£9.99

  

  Motor Wheel Encoder sensor module  with 3 x 20cm male to male cable

 Purpose:
Widely used in motor speed detection, pulse counting, position limit and so on.
Module Features:
1. the use of imported groove coupler sensor
2. the slot width 5mm.
3. the output state indicator lamp output high, output low lights.
4. with cover, high output; unobstructed, output low.
5. the comparator output signal clean waveform is good, driving ability, than 15mA.
6. Operating Voltage 3.3V-5V
7. the output format: Digital switching output (0 and 1)
8. a fixed bolt holes for easy installation
9. small plates PCB size: 3.2cm x 1.4cm
10. using a wide voltage LM393 comparator


Module for use:

(1) module slot unobstructed, the receiver tube is turned on,

 the module DO output low, cover when, DO output high.


(2) DO module can be connected to the relay, consisting limit switches and other functions,

    can also be connected with the active buzzer module, composed of alarm.

 

 

 

  

(1) GPIO wheel Encoder

 

 

  

 

Python WheelEncoder.py   DEMO

Python WheelEncoder.py   DEMO
Sudo python WheelEncoder.py  17  3  23 
                             
 17  GPIO for Encoder    3  Rotation   
  23  Motor connect to GPIO 23

 

Support our Pi_Scratch software   Detail

Scratch control demo

Command “23” + “MOTORDIS” “17”+ “S” + “3” 
  17  GPIO for Encoder    3  Rotation   
  23  Motor connect to GPIO 23 

 

(2) i2c 23017 GPIO wheel Encoder

 

i2c wheel encoder python  I2Wheel.py demo

Sudo python I2Wheel.py  21 A  2  17 5

  21 = Address of the I2C 23017
  A = Bank A
  2 = Bit 2 / pin 2 (1 - 8)
  17 = GPIO Pin 17 , 18 for motor control through

    our L293D Motor control board

  2 = Rotate 2 times.

 

Scratch control demo

Command format
I2MOTORDIS[Address][Bank][Encoder Pin]M[Motor Pin]R[Rotations]
 
I2MOTORDIS21A2M17R2

1. Address = 20 - 27, Address for the I2C  
2. DeviceBank = A or B ( Bank for the encoder ) 
3. Encoder Pin = 1 - 8 ( Pin number for the encoder )
4. Motor Pin = GPIO Pin number for the Motor   
    For example our Motor Board use GPIO 17 & 18  
    control 2 Motor forward & backward
5.  Rotations = How many rotations you want the Motor to do 
     before it stops.       minimum input 0.2  

 

Demo Python program

 WheelEncoder.py     I2Wheel.py    User Manual

                    

Package Content

  1x Rs-Pi  Motor Speed Encoder 2 Port module

4x 20cm male to male cable

1x manual 

  

 
 

Raspberry Pi

iPad  iPhone

Products  

 

 

      

 Flag Counter

 

 

                   

   Scratch driver for Raspberry Pi

Pi_Scratch software

 

 

Copyright ?009
www.pridopia.co.uk
All rights reserved

Home           About us           Support           Shopping           Contacts            FAQ