RS232 x4 /RS485 x4  for Raspberry Pi  B+ 2B 3B & Pi Zero

   

1. Provide RS232 x4 / RS485 x4 
2. Jumper setting RS232 / RS485 output
3. RS485 auto RTS control by software
4. It provides an individual 3.3V power for UART Board
5. Provide HAT EEPROM for future driver program update.
6. Raspberry Pi model 3B & Pi Zero W still can use on board Bluetooth & WiFi

 

 

 

  4 Port RS232 with standard DB9 output

 4 Port RS485 with 2.54mm pitch 2p terminal block output

  Male DB9 Pin 1  to Pin9  output 

 DCD , RXD, TXD, DTR, GND, DSR, RTS, CTS, RI

 

                                                      

Serial GUI Control Panel
Control up to 4 Serial Ports

                        

  • 1. Scan: Scan for available UART devices.
  • 2. Launch cutecom together when starting Serial Port.
  • 3. Port number in system
  • 4. Baud Rate choose
  • 5.6.7.  UART Port  Information:  Port Address 0x48,0x49, 0x4c, 0x4d

              Chip Address Location, Channel Number ( 1 / 2 ), TX and RX receive counter,

              and Serial port Location /dev/pts/X

  • 8. RS485 : Enable RS485 in this Port
  • 9. Start : Start UART port

 

Also provided is a terminal command mode to activate serial ports through a terminal / ssh.
You can also activate a serial port on boot up with the provided software.
Commands for starting the serial ports via command line;
./Pi232 -a ADDR -c CHANNEL -b BAUD -s DEVPTS

./Pi485 -a ADDR -c CHANNEL -b BAUD -s DEVPTS


ADDR = Address of Serial Port e.g. 0x48, 0x49, 0x4C, and 0x4D
CHANNEL = Channel of serial Port ( 1 / 2 )
BAUD = Baud Rate for the Serial Port
DEVPTS = PICOM Service Number ( Will direct the filename to /dev/picomX where X = your number )


For example, To start a serial port from 0x49, on channel 2 with 115200 Baud run the following;
./Pi232 -a 0x4d -c 2 -b 115200 -s 1
This will activate the serial port and then set /dev/picom1 to your serial port location /dev/pts/X

./Pi485 -a 0x4c -c 2 -b 115200 -s 1
This will activate the serial port and then set /dev/picom1 to your serial port location /dev/pts/X

 

 

     Enable RS232 in command mode   

 

 

  Enable RS485 in command mode

 

 

   

1. device ->   /dev/pts/1        2 . Baud rate  38400

3. click Open device  

4. input AT command (HC-05 blutetooth module)

5. screen will show Bluetooth module response  

 

 
type "top" in terminal 
Enable 4 Port RS232 x2 - RS485 x2 
 You will see 2 x Pi232 & 2 x Pi485 run in system 
 
 
 
File Download      

  Software Pack

  User Manual

 

Package Content

   1x  4xUART Main board

1x  4x RS232 - RS485 module  board

1x manual 

  

 
 

Raspberry Pi

extra UART

Products  

 

 

  

 

 Flag Counter  

Copyright ?009
www.pridopia.co.uk
All rights reservedd

Home           About us           Support           Shopping           Contacts            FAQ